|
|
|
DIAMOND GANG SAWS
Offering
Speed, Precision, & Cost Savings. Designed for machining materials
such as Glass, Quartz, Ceramics, and Metals. Cut 10 times faster
over conventional sawing methods. Can cut:
400 to
6,000 parts per minute -
40/1000 to 59 parts in length -
Precision Tolerances
+ 1/200
|
Diamond Gang Saw Model 1392
Model
1392 is the smallest PSS designed to cut small diameter tubing
and rod with a starting length of 4" to 13" into
small lengths. Long lengths are easily accommodated but at
a reduction in production. more... |
Diamond Gang Saw Model
2491
Model 2491 is
the middle of the road PSS. It was designed to cut a range of
diameters from 0.050" to 1.0" and part lengths from
0.050" to 24". Stock tube lengths can be as small
as 4" up to 24". Production is determined by a
combination of stock tube diameter and part length. more...
|
|
Diamond Gang Saw Model
5996
Model 5996
accepts stock material up to 59" in length and cut diameters
ranging from 0.150" to 0.250". more...
|
Diamond Gang Saw Model
4896
Model 4896 is
designed to accommodate raw materials up to 48" in length.
The various models cut stock as small as 0.100" in diameter up to
3.0". more...
|
|
|
Features:
Uncut
tubes are loaded into a hopper, the transported automatically between
the feed roller and holding sheet. Multiple cutting wheels
pass through slots in the holding sheet and cut each tube. This assures
that the cutting action is always from the outside of each tube toward
its center. This minimizes chipping or burring of the cut parts.
|
Made in U.S.A.
|
|
SMART
CUT™
Expect
MORE
from your tools.
|
Advantages:
-
NO
POTTING REQUIRED!
-
Production
rates range from 400 to 6000 parts per minute
-
Multi-Blade
cutting system makes all cuts simultaneously and automatically
separates end cuts from finished pieces.
-
Capable of
cutting tubes or rods of glass, quartz, carbon, ceramics, plastics,
fibre glass, hybrid and exotic materials and most metals. If
it is a rod or a tube it can be cut on this system!
-
Simple,
hopper fed operation allows one person to operate multiple machines.
-
Normal
length tolerance is +/- .002". Squareness is +/- 1.0 degrees.
-
Stock
material diameters currently range from 0.030" to 3.0".
-
Uses water
as a coolant. Can also use additives and lubricants as desired
|
|
|
